Have you done as requested earlier.
check your HDMI cabling and EDID status:
power off your PI
remove the SD card
power on the pi.
- you should get the diagnostic display as shown below. Pay attention to the EDID data status (the last line "display"... below says EDID=OK)
check your HDMI cabling and EDID status:
power off your PI
remove the SD card
power on the pi.
- you should get the diagnostic display as shown below. Pay attention to the EDID data status (the last line "display"... below says EDID=OK)
Statistics: Posted by drgeoff — Wed Feb 21, 2024 1:57 pm