Thank you for your suggestions!
Not sure about the second option, though, as it still violates the HAT+ requirement I mentioned above and also against "5.1.1 GPIO Pin Assignments" from the R-Pi4 datasheet(page 9):
Not sure about the second option, though, as it still violates the HAT+ requirement I mentioned above and also against "5.1.1 GPIO Pin Assignments" from the R-Pi4 datasheet(page 9):
Code:
DO NOT USE these pins for anything other than attaching an I2C ID EEPROM. Leave unconnected if ID EEPROM not required.Statistics: Posted by bao-eng — Thu Dec 26, 2024 5:40 pm